tag:blogger.com,1999:blog-8531974914177620074.post3913243260610305057..comments2024-01-07T23:40:37.989-05:00Comments on My Life as a Tinkerer: Printrbot Build: Part 2Dillonhttp://www.blogger.com/profile/02449340348061028641noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-8531974914177620074.post-2210722020585595372012-11-25T22:45:28.351-05:002012-11-25T22:45:28.351-05:00It looks like you did a good job, I hope you have ...It looks like you did a good job, I hope you have more luck than I've had calibrating as I can not get the extruder to move it says can't move with cold injector. I can't get the z axis to home it goes up about 10 mm when I try.<br />When I tried a small print and the injector got hot by would not print and no way to read what tempature it was at.<br />Roy<br />Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-8531974914177620074.post-81204276422484804792012-07-20T14:36:39.703-04:002012-07-20T14:36:39.703-04:00Hi Dillon, this is an awesome guide! Can you re-cr...Hi Dillon, this is an awesome guide! Can you re-create it on the official Printrbot Community Support Site - printrbot.dozuki.com. <br /><br />Brook and his team are working hard to create step-by-step guides like this, but they could use more help. <br /><br />Thanks!Anonymousnoreply@blogger.com